PixelSearch

PixelSearch, OutputVarX, OutputVarY, X1, Y1, X2, Y2, ColorID [, Variation, Fast|RGB]

OutputVarX/Y

The names of the variables in which to store the X and Y coordinates of the first pixel that matches ColorID (if no match is found, the variables are made blank). Coordinates are relative to the active window unless CoordMode was used to change that.

Either or both of these parameters may be left blank, in which case ErrorLevel (see below) can be used to determine whether a match was found.
X1, Y1 The X and Y coordinates of the upper left corner of the rectangle to search, which can be expressions. Coordinates are relative to the active window unless CoordMode was used to change that.
X2, Y2 The X and Y coordinates of the lower right corner of the rectangle to search, which can be expressions. Coordinates are relative to the active window unless CoordMode was used to change that.
ColorID The decimal or hexadecimal color ID to search for, in Blue-Green-Red (BGR) format, which can be an expression. Color IDs can be determined using Window Spy (accessible from the tray menu) or via PixelGetColor. For example: 0x9d6346
Variation A number between 0 and 255 (inclusive) to indicate the allowed number of shades of variation in either direction for the intensity of the red, green, and blue components of the color (can be an expression). This parameter is helpful if the color sought is not always exactly the same shade. If you specify 255 shades of variation, all colors will match. The default is 0 shades.
Fast|RGB

This parameter may contain the word Fast, RGB, or both (if both are present, separate them with a space; that is, Fast RGB).

Fast: Uses a faster searching method that in most cases dramatically reduces the amount of CPU time used by the search. Although color depths as low as 8-bit (256-color) are supported, the fast mode performs much better in 24-bit or 32-bit color. If the screen's color depth is 16-bit or lower, the Variation parameter might behave slightly differently in fast mode than it does in slow mode. Finally, the fast mode searches the screen row by row (top down) instead of column by column. Therefore, it might find a different pixel than that of the slow mode if there is more than one matching pixel.

RGB: Causes ColorID to be interpreted as an RGB value instead of BGR. In other words, the red and blue components are swapped.


Example

PixelSearch, Px, Py, 200, 200, 300, 300, 0x9d6346, 3, Fast
if ErrorLevel
MsgBox, That color was not found in the specified region.
else
MsgBox, A color within 3 shades of variation was found at X%Px% Y%Py%.